CHAPTER 5 PARAMETERS
E5EK
5--30
•
The parameters in this mode can be used only when the “security” parameter
(protect mode) is set to “0” and “1”.
•
This mode contains the parameters for checking or setting the basic specifications
of the E5EK-T controller. These parameters include parameters for specifying the
input type, scaling, output assignments, and direct/reverse operation.
•
To select this mode, press the
key for 1 second minimum. The display changes
to the menu display. If you select [
] pressing the
and
keys, and then
press the
key for 1 second minimum, the controller enters the setup mode.
•
To select parameters in this mode, press the
key. To change parameter set-
tings, use the
or
keys.
•
The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol
Parameter Name
Page
Input type
5-31
Scaling upper limit
5-32
Scaling lower limit
5-32
Decimal point
5-32
_
C/
_
F selection
5-33
Parameter initialize
5-33
Control output 1 assignment
5-34
Control output 2 assignment
5-34
Auxiliary output 1 assignment
5-35
Auxiliary output 2 assignment
5-35
Alarm 1 type
5-36
Alarm 1 open in alarm
5-37
Alarm 2 type
5-36
Alarm 2 open in alarm
5-37
Alarm 3 type
5-36
Alarm 3 open in alarm
5-37
Direct/Reverse operation
5-37
Setup Mode
Summary of Contents for E5EK
