Omron E5EK, User Manual

Page: 101 / 203

E5EK
5--11
•
The parameters in this mode can be used only when the “security” parameter
(protect mode) is set to “0” to “4”.
•
This mode contains the parameters that you use for programming.
•
To select this mode, press the key for 1 second minimum. The display changes
to the menu display. If you select [ ] using the and keys, and then
press the key for 1 second minimum, the controller enters the program mode.
•
To select parameters in this mode, press the key. To change parameter set-
tings, use the or keys.
•
The following table shows the parameters supported in this mode and the page
where the parameter is described.
Symbol
Parameter Name Page
Pattern No. 5-7 *1
Number of steps 5-12
Step 0 SP or Target SP 0 5-12
Ramp rate 0 5-13
Step 0 time or Soak time 0 5-13
| |
Step 7 SP or Target SP7 5-12
Ramp rate 7 5-13
Step 7 time or Soak time 7 5-13
Step 8 SP 5-12
Step 8 time 5-13
|
|
Step 15 SP 5-12
Step 15 time 5-13
Pattern execution count 5-14
Alarm value 1 5-14
Alarm value 2 5-14
Alarm value 3 5-14
Time signal 1 enabled step 5-15
Time signal 1 ON time 5-15
Time signal 1 OFF time 5-16
Time signal 2 enabled step 5-15
Time signal 2 ON time 5-15
Time signal 2 OFF time 5-16
*1 This parameter is described as a level 0 mode parameter. For details, see page 5-7.
Program Mode