Omron E5EK, User Manual

Page: 21 / 203

1.4 Parameters and Menus
E5EK
1--11
•
Protected modes cannot be selected. Also, the menu display does not
appear when modes are protected up to the program mode.
•
If you select [ ], [ ], [ ] or [ ] in the menu display,
the level 0, program, level 1 and level 2 modes, respectively, are se-
lected.
These modes are selected with control still continuing.
•
If you select[ ] [ ] [ ] or [ ] in the menu display, the
setup, expansion, option and calibration modes, respectively, are se-
lected.
When these modes are selected, the control is reset. So, control out-
puts and auxiliary output are turned OFF. When another mode is se-
lected while in these modes control, reset is canceled.
•
To set the controller to the protect mode or to return to the level 0
mode from the protect mode, press the
RUN/RST
key and the key
simultaneously for 1 second minimum.
•
To set the controller to the manual mode, press the key for one
second minimum with the key held down in the level 0 to 2
modes. To return to the level 0 mode in the manual mode, press the
key for one second minimum with the key pressed. Be sure
to press the key first in this operation.
•
When the controller is not in the manual mode, each press of the
key switches the parameter in the respective mode.
Parameter
1
Parameter
2
Parameter
3
Parameter
n
•
If you press the key when at the final parameter, the display re-
turns to the top parameter for the current mode.
•
When you change parameter settings or contents, specify the parame-
ter using the
or keys, and either leave the setting for at least
two seconds or press the key. This fixes the setting.
•
When another mode is selected, the content of the parameters before
the mode was selected is fixed.
•
When you turn the power OFF, you must first fix the settings and pa-
rameter contents (by pressing the
key or selecting another
mode). The settings and parameter contents are sometimes not
changed by merely pressing the
or keys.
J
Selecting
parameters
J
Fixing settings