Omron CX-PROGRAMMER V9, Operation Manual

Page: 298 / 536

PART 2: CX-Server PLC Tools
OMRON CHAPTER 5 – Data Trace/Time Chart Monitor Component
CX-Server PLC Tools_ Page 55
Item Function
[Left Operand] Input Symbol or the address to be trigger object. Select data
type from Combobox.
1ch data, 2ch data and 4ch data can be set on CJ2 CPU. 1ch
data can be set on PLC of CS/CJ/CP Series other than CJ2
CPU. [Trigger
Settings]
[Browse] Search trigger object from Symbol Table.
[Formula] Select the conditions of Trigger completion.
When [Left Operand] is a bit (data type is BOOL).
↑ Falling Edge
↓
Rising Edge
[Left Operand] is other than the above:
=
Equal
≠ Not equal *2
<
Less than~ *2
> More than~ *2
≤
Maximum *2
≥ Minimum *2
[Trigger
Settings]
[Right Operand] Input the value to be Trigger. Input is enabled when [Left
Operand] is other than a bit (data type is except for BOOL).
[Delay] Input delay value in sample number. Input in slider is possible.
[No. of Trace Samples] When using all trace memory CPU Unit is not necessary, input
sampling number to be traced. Time per trace execution time will
be shorter. *2
[Auto Repeat] Check, Box Check the box when executing trace on auto repeat under the
same conditions.
[No. of Trace Execution] Input the number of trace to be executed repeatedly. When
[Auto Repeat] check box is checked, input is enabled.
[Trace Start on Monitor/Run
Mode] Check Box Start trace automatically at the timing when PLC mode changes
to Monitor mode, or Run Mode (includes Power on).*1
[Trace Start Executing
Automatically After Download]
Check Box Check the box when starting Data Trace automatically after
transferring the execution conditions of Data Trace to PLC.
*2: Settable Only on CJ2 CPU.