Omron CP1L-L14D Series, Operation Manual

Page: 213 / 671

180
Pulse Outputs Section 5-2
5-2-2 Pulse Output Specifications
Specifications
Pulse Output Modes
There are two pulse output modes. In independent mode the number of out-
put pulses is specified and in continuous mode the number of output pulses is
not specified.
Item Specifications
Output mode Continuous mode (for speed control) or independent mode (for position control)
Positioning (independent mode)
instructions PULS(886) and SPED(885), PULS(886) and ACC(888), or PLS2(887)
Speed control (continuous mode)
instructions SPED(885) or ACC(888)
Origin (origin search and origin
return) instructions ORG(889)
Output frequency Pulse outputs 0, 1: 1 Hz to 100 kHz (1 Hz units)
Frequency acceleration and decel-
eration rates Set in 1 Hz units for acceleration/deceleration rates from 1 Hz to 65,635 Hz (every 4
ms). The acceleration and deceleration rates can be set independently only with
PLS2(887).
Changing SVs during instruction
execution The target frequency, acceleration/deceleration rate, and target position can be
changed.
Duty factor Fixed at 50%
Pulse output method CW/CCW inputs or Pulse + direction inputs
The method is selected with an instruction operand. The same method must be used
for pulse outputs 0 and 1.
Number of output pulses Relative coordinates: 0000 0000 to 7FFF FFFF hex
(Each direction accelerating or decelerating: 2,147,483,647)
Absolute coordinates: 8000 0000 to 7FFF FFFF hex
(
−
2147483648 to 2147483647)
Pulse output PV's relative/absolute
coordinate specification Absolute coordinates are specified automatically when the origin location has been
determined by setting the pulse output PV with INI(880) or performing an origin
search with ORG(889). Relative coordinates are used when the origin location is
undetermined.
Relative pulse specification/
Absolute pulse specification
The pulse type can be specified with an operand in PULS(886) or PLS2(887).
Note The absolute pulse specification can be used when absolute coordinates are specified for
the pulse output PV, i.e. the origin location has been determined.
The absolute pulse specification cannot be used when relative coordinates are specified,
i.e. the origin location is undetermined. An instruction error will occur.
Pulse output PV's storage location The following Auxiliary Area words contain the pulse output PVs:
Pulse output 0: A277 (leftmost 4 digits) and A276 (rightmost 4 digits)
Pulse output 1: A279 (leftmost 4 digits) and A278 (rightmost 4 digits)
The PVs are refreshed during regular I/O refreshing.
Acceleration/deceleration curve
specification Trapezoidal or S-curve acceleration/deceleration
Mode Description
Independent mode This mode is used for positioning.
Operation stops automatically when the preset num-
ber of pulses has been output. It is also possible to
stop the pulse output early with INI(880).
Continuous mode This mode is used for speed control.
The pulse output will continue until it is stopped by
executing another instruction or switching the PLC to
PROGRAM mode.