Ohmart Vega W-4510, Technical Reference Hardware Manual

Page: 154 / 162

Appendix I: Parameter blocks
W-4510 Weigh Scale Technical Reference Manual 137
Screen 528 Linearizer Block
528 LINEAR CURVES \n
ITEM 000 NEXT=000
CURRENT VAL NEW VAL
00000 00000
Figure 69: Linearizer curve screen
The base address for screen 528 LINEAR CURVES is 529, item 512.
The n on the top line is a number from 0 to 9. This number is the current linearizer curve that
you are accessing. The value of n can be incremented by pressing the HELP key.
Table 32: Screen 528 Linearizer block
Item# Parameter Name Parameter description
0 CURVE Start of 40-slope linearizer curve. Uses 41 locations. Curve in normalized units,
usually 0 to 10,000. (i.e., 0–100%)
1 The percent of process span that corresponds to 2.5% of the count range
2 The percent of process span that corresponds to 5.0% of the count range
…
40 HIGH END POINT
OF CURVE
41 CURVE STATUS 0=no curve data entered, 1=40 point curve entered- 41 locations
42 LOW PRODUCT
VALUE Value of low end of curve in product units. These are Ohmart product units for
calibration
43 HIGH PRODUCT
VALUE Value of high end of curve in product units for calibration purposes
44 SPARE
45 SPARE
46 SPARE
47 SPARE
48 SPARE
49 SPARE