Ohmart Vega W-4510, Technical Reference Hardware Manual

Page: 104 / 162

Calibration
W-4510 Weigh Scale Technical Reference Manual 87
Procedure 25: Collect data for zero Channel #1—low on process
1. For the zero, run an empty belt
2. From the MAIN MENU 1 OF 2 screen, press SELECT to choose CALIBRATE
SYSTEM and press ENTER
3. From 018 CAL MENU 1 OF 2 screen, press SELECT to choose CALIBRATE GAGE
and press ENTER
4. From 008 CALIBRATE GAGE screen, press ENTER at SELECT CHANNEL
Note: Verify that you are using the correct product code (0-8 for Channel #1 or 9 for
Channel #2)
5. From 146 CAL CHANNELS screen, select CAL CHANNEL #1 and press ENTER
6. From 149 CAL CHANNEL #1 screen, press SELECT to choose MORE CAL
FUNCTIONS and press ENTER
7. From 150 CAL CHANNEL #1 screen, press SELECT to choose MORE CAL
FUNCTIONS and press ENTER
8. From 151 CAL CHANNEL #1 screen, press SELECT to choose MORE CAL
FUNCTIONS and press ENTER
9. From 152 CAL CHANNEL #1 screen, press SELECT to choose CAL LO ON
PROCESS and press ENTER
10. From 210 CALIBRATE LOW ON PROCESS screen, press SELECT to choose either
YES or NO (ABORT)
11. From 211 CAL TIME LEFT , press ENTER when the countdown reaches 0
12. From 212 ENTER PROD VAL screen, enter the actual value of the process and
press ENTER. Screen 212 displays again with the cursor on the YES line. Press
ENTER to continue
13. On the 157 SAVE CALIBRATE RESULT IN UPPER RAM? screen, press ENTER on
the YES line to save to upper RAM or NO to abort the save
14. If you choose to save the results, the AVG. COUNT stores in memory for later use.
Do this only when you are sure the results are correct and you are ready to continue
15. Press SELECT to choose the YES and press ENTER to continue
16. Connect the write protect jumper, JP17 and save to EEPROM
17. Disconnect the write protect jumper, JP17.