Ohmart Vega W-4510, Technical Reference Hardware Manual

Page: 119 / 162

Calibration
102 W-4510 Weigh Scale Technical Reference Manual
Procedure 35: Collect data for span Channel#2—high process
1. From the MAIN MENU 1 OF 2 screen, press SELECT to choose CALIBRATE
SYSTEM and press ENTER
2. From 018 CAL MENU 1 OF 2 screen, press SELECT to choose CALIBRATE
GAGE and press ENTER
3. From 008 CALIBRATE GAGE screen, press ENTER at SELECT CHANNEL
Note: Verify that you are using the correct product code (0-8 for Channel #1 or 9
for Channel #2)
4. From 146 CAL CHANNELS screen, select CAL CHANNEL #2 and press ENTER
5A. From 185 CAL CHANNEL #2 screen, press SELECT to choose CAL HI ON
PROCESS and press ENTER
5B. Turn off the source, load belt statically, and turn on source. Try to replicate the
loading profile
6. From 200 CALIBRATE HI ON PROCESS screen, press SELECT to choose either
YES or NO
7. From 201 CAL TIME LEFT AFTER TIMEOUT , press ENTER when the countdown
reaches 0 seconds left
Note: Stop the conveyor at this point and collect a known length of the material.
Weigh the material and determine the lbs/ft
8. From 202 ENTER PROD VAL screen, enter the actual value of the process and
press ENTER. Screen 156 displays again with the cursor on the YES line. Press
ENTER to continue
9. On the 157 SAVE CALIBRATE RESULT IN UPPER RAM? screen, press ENTER
on the YES line to save to upper RAM or NO to abort the save
10. If you choose to save the results, the AVG. COUNT stores in memory for later use.
11. Press SELECT to choose the YES and press ENTER to continue
12. Connect the write protect jumper, JP17 and save to EEPROM
13. Disconnect the write protect jumper, JP17.