Ohmart Vega W-4510, Technical Reference Hardware Manual

Page: 19 / 162

Introduction
2 W-4510 Weigh Scale Technical Reference Manual
Unpacking the equipment
CAUTION!
Make sure that you are familiar with radiation safety practices in
accordance with your U.S. Agreement State, U.S. NRC, or your
country’s applicable regulations before unpacking the equipment.
5
Unpack the unit in a clean, dry area
5
Inspect the shipment for completeness, by checking against the packing slip
5
Inspect the shipment for damage during shipment or storage
5
If the detector is included as a separate package in the shipment, inspect the assembly for
damage that may have occurred during shipment or storage
5
If there was damage to the unit during shipment, file a claim against the carrier and report
the damage in detail. Any claim on the Ohmart Corporation for shortages, errors in
shipment, etc., must be made within 30 days of receipt of the shipment
5
If you need to return the equipment, see the section “Returning equipment for repair to
Ohmart” in the “Diagnostics and Repair” chapter
5
After you unpack the equipment, inspect each source holder in the shipment to assure that
the operating handle is in the OFF position. In the event that you find the handle in the ON
position, place it in the OFF position immediately and secure it.
Note: Most source holder models accept a lock. Call Ohmart Field Service
immediately for further instructions, at 513-272-0131, if the source holder
has one of the following conditions:
•
Does accept a lock and there is no lock on it
•
The lock is not secured
•
You are unable to secure the lock
•
The operating handle does not properly move into the off position