Oce VarioPrint 2100, User Manual

Page: 276 / 308

276 Chapter 10 Add the supplies
Replace the stapler cartridges 1 and 2 (standard on-line staplers)
Note: The staplers must be extended to the maximum position. If the staplers are not
in the correct position, you cannot access stapler 1. Follow the procedure below if
the staplers are not correctly aligned.
4.
Tilt the stapler cartridge forward.
5.
In the same movement, remove the stapler cartridge from the stapler.
6.
Remove the loose staples if necessary.
Note: Make sure that no staples fall into the finisher.
7.
Take a new cartridge, type S3.
8.
Remove the packing material.
9.
Slide the stapler cartridge into the stapler.
10.
Press until the stapler cartridge clicks into place.
Note: If the new stapler cartridge does not fit, put back the old stapler cartridge and
call service.
11.
Close the top cover of the finisher.
12.
Close the front door of the finisher.
How to align the staplers correctly
1.
Close the top cover of the finisher if the staplers are not in the correct position.
2.
Pull stapler 2 toward you until the stapler cannot go any further.
3.
Open the top cover of the finisher again.
Note:
You can access stapler 1 when the stapler cartridge is tilted upward.