Nortel VoIP Gateway, Configuration Manual, Page: 76 / 220

76 Configuring the Channel Settings
P0606298 02
b
Click the Save Configuration button that is in middle of the screen.
A confirmation message appears when the save is complete.
Configuring the Channel Settings
The Channels Settings screen allows you to set the VoIP Gateway channel parameters, such as
Input and Output voice gain, Jitter buffer characteristics, Modem, Fax and DTMF transport modes.
These parameters apply to all VoIP Gateway ports.
To configure the Channel Settings:
1
Access the web interface.
2 Click the Advanced Configuration button.
3 Click the Channel Settings tab.
The Channels Settings screen appears
Note: The Save Configuration option is useful for trying out a new configuration.
Simply make the change and try out the new configuration. If you are happy with the
new configuration, save the changes to non-volatile memory. If you are not happy
with the new configuration, do not save the changes to non-volatile memory and
remove power from the VoIP Gateway. The VoIP Gateway will return to the previous
configuration.
Note: Nortel Networks recommends that you do not change any settings on the Channel
Settings screen except when instructed to do so by Nortel Networks service personnel.
Note: Set the Loss Plan setting for the Norstar analog loop start lines to MediumCO. You
set the Norstar Loss Plan settings using **CONFIG programming.