Nortel VoIP Gateway, Configuration Manual, Page: 120 / 220

120 Example configurations
P0606298 02
Setting up the VoIP Gateway dialing plan – Hunt Groups
On the Channels - Hunt Group screen:
1 Make an entry for each channel used.
2 For each channel, enter the E.164 number for that location. This will be the same number.
3 Assign each channel to Hunt Group 1.
Figure 29 shows the Channels - Hunt Group settings for the Head Office VoIP Gateway.
Figure 29 Channels - Hunt Group screen for simple Norstar network
Setting up the VoIP Gateway dialing plan – IP Routing Table
On the Tel To IP Routing & IP Security screen:
1 Enter the digit parsing rule for the number.
2
Enter the IP address of that destination.
In the sample screen shown in Figure 30 , note that there are two entries for the Calgary office, one
for private network calls and one for Toll bypass (PSTN) calls. Also note that the last entry is “*”
which means the rule applies to everything that does not match a higher rule. In this case, those
calls are not routed.
Figure 30 shows the Tel To IP Routing & IP Security settings for the Head Office VoIP Gateway.