Nortel VoIP Gateway, Configuration Manual

Page: 88 / 220

88 Contents of the INI file
P0606298 02
Basic, Logging and Web parameters
Table 14 describes the parameters that are found in the Basic, Logging and Web parameters section
of the INI file.
Table 14 Basic and Logging parameters
INI File Field Name Valid Range and Description
MGControlProtocolType 4 = for H.323 gateway
DSPVersionTemplateNumber 0 = Firmware DSP version supports PCM/ADPCM, G723 and G729 Coders
(default)
1 = Firmware DSP version supports PCM/ADPCM, and NetCoder coders
2 = Same as "0" but with voice and energy detectors
3 = Same as "1" but with voice and energy detectors
DSP templates 2 or 3 should be selected for Disconnect supervision feature,
enabled by: "EnableSilenceDisconnect = 1".
EthernetPhyConfiguration 0 = 10 Base-T half-duplex
1 = 10 Base-T full-duplex
2 = 100 Base-T half-duplex
3 = 100 Base-T full-duplex
4 = auto-negotiate (Default)
Auto-negotiate falls back to half-duplex mode (HD) when the opposite port is not
in auto-negotiate, but the speed (10 Base-T, 100 Base -T) in this mode is always
configured correctly.
DHCPEnable 0 – Disable (default)
1 – Enable
After the gateway is powered up it will try first to communicate with BootP server.
If BootP server is not responding and "DHCPEnable =1" the gateway will send
DHCP request to configure its IP address and other network parameters from
the enterprise DHCP server.
BootPRetries 1 = Single BootP request.
2 = 2 BootP retries - (3 seconds).
3 = 3 BootP retries - (default, 6 seconds)
4 = 10 BootP retries - (30 seconds).
5 = 20 BootP retries - (60 seconds).
6 = 40 BootP retries - (120 seconds).
7 = 100 BootP retries - (300 seconds).
15 = BootP retries forever.
Number of BootP retries, and then DHCP retries (if DHCPEnable = 1) at
gateway startup.
Note: BootPRetries parameter becomes active after the VoIP Gateway is reset
and
INI file is loaded. To change the parameters, first modify the INI file, and
then reset the gateway.
EnableDiagnostics 0 = No diagnostics (default)
1 = Perform diagnostics
WatchDogStatus 0 = Disable gateway’s watch dog
1 = Enable gateway’s watch dog (default)
EnableLanWatchDog 0 - Disable LAN WatchDog (default)
1 - Enable LAN WatchDog
When enabled, the VoIP Gateway is restarted if a LAN failure is detected.
SysLogServerIP IP address in dotted format notation, e.g., ‘192.10.1.255’