Nortel VoIP Gateway, Configuration Manual

Page: 180 / 220

180 CSE 1000 Gatekeeper
P0606298 02
Committing Gatekeeper Configuration Changes
Gatekeeper configuration changes occur in the standby database. For these to be used by the active
gatekeeper, they must be committed to the active database, as follows.
In the Gatekeeper Admin tool:
1
Select GK Standby DB Admin.
2 Select Database Actions.
3
Select Single Step Commit and Crossover.
Programming the VoIP Gateway to work with a CSE 1000
Gatekeeper
Use the following programming on the VoIP Gatewayfor interoperability with the CSE1K
Gatekeeper. In the VoIP Gateway browser, set the following:
• Protocol Management / Protocol Definition / Working with Gatekeeper = Yes
• Protocol Management / Protocol Definition / Gatekeeper IP Address = IP address of the CSE
1000 Gatekeeper
• Protocol Management / Protocol Definition / Gatekeeper Redundancy = No
• Protocol Management / Protocol Definition /Gateway Registration Type = H.323-ID
• Protocol Management / Protocol Definition / H.323-ID = Same unique H.323 ID as was used
in setting up the H.323 Alias Name in the gatekeeper
• Protocol Management / Protocol Definition / Register as Terminal = No
• No entries are required in the Registration Prefixes table.
• Protocol Management / Protocol Definition / Gatekeeper Timers should be left at their default
values.
• Optionally, the Tel to IP Routing table may be filled in for all network destinations and
Protocol Management / Protocol Definition / Fallback to Internal Routing set to “yes”. With
this setup, if the CSE 1000 Gatekeeper should fail or be unavailable, the VoIP Gateway will
revert to its internal routing tables for call setup.
• Dialing plan used must match the dialing plan setup for the gatekeeper (structure of digits).
The CSE 1000 Gatekeeper does not check the NPI / TON classification of the destination
digits in order to resolve the address.