Nortel VoIP Gateway, Configuration Manual, Page: 59 / 220

Configuring the Channels to Hunt Group parameters 59
Norstar VoIP Gateway Configuration Guide
4
Configure the End Point’s Phone Numbers according to the following table.
You must enter a number in the Phone Number boxes for each port that you want to use.
5 Click the Submit button to save your changes.
6
To apply the changes, you must reset the VoIP Gateway. To reset the VoIP Gateway:
a Click the Reset button.
b
Click the Restart button.
A confirmation dialog box appears.
c
Click the OK button.
7 To save the changes so they are available after a power fail, you must save the changes to
non-volatile memory. To save the changes to non-volatile memory:
Table 10 End Point’s Phone Numbers
Parameter Description
Channel(s) The numbers in the Channel(s) boxes represent the ports on the back of the VoIP
Gateway.
To enable a VoIP Gateway channel, you must enter the port number on this screen.
Phone Number In each of the Phone Number boxes, enter the telephone number that is assigned to that
channel.
You must enter a telephone number for a channel to enable that channel.
If you want to disable a port, leave the Phone Number box for that channel blank.
The Phone Number you enter is the “source” number in the protocol. Also, if you are not
using the Digit Manipulation tables, the Phone Number you enter on this screen is
presented as the Calling Line Identification information on the destination set.
Recommendations:
If the analog loop start lines are configured as one dedicated line per Norstar set, enter a
unique phone number for each channel.
If the analog loop start lines are configured in a line pool, enter the same phone number
for all of the channels. The phone number you enter would typically be the main number
required to reach a receptionist.
If you assign unique phone numbers to channels configured in a line pool, the calling line
identification information would become confusing, since many Norstar sets may have
access to the same channel.
Hunt Group Id In each of the Hunt Group Id boxes, enter the Hunt Group ID assigned to the channel. The
same Hunt Group ID can be used for more than one channel.
The Hunt Group ID is an optional field that is used to define a group of channels that are
used for routing IP to telephone calls. If an incoming call is assigned to a Hunt Group, the
call is routed to the channel or channels that correspond to the Hunt Group ID enter here.
In most situations, the application will need all 4 channels assigned to one hunt group.
Important: If you enter a Hunt Group Id, you must configure the IP to Hunt Group Routing
Table. If you do not configure the IP to Hunt Group Routing Table, calls will not complete.
For information about how to configure this table, refer to
“Configuring the IP to Hunt
Group Routing” on page 67 .
Note: Only the entries for the first four channels are supported on the VoIP Gateway.