Nortel VoIP Gateway, Configuration Manual

Page: 63 / 220

Configuring the Caller ID Display 63
Norstar VoIP Gateway Configuration Guide
Configuring the Caller ID Display
The Caller ID Display Table contains the Caller ID information that is sent when a call is made
using the VoIP Gateway. The person receiving the call can use this information for caller
identification. The information on this table is sent in the H.225 Setup message sent to the remote
party.
To configure the Caller ID Display Table:
1 Access the web interface.
2
Click the Protocol Management button.
3 Click the Caller ID tab.
The Caller Display Info screen appears.
Figure 12 Caller Display Info
4 In the Caller ID/Name box, enter the Caller ID string that sent when a call is made using this
VoIP Gateway port.
The caller ID string can contain up to 18 characters, but Nortel Networks recommends that
you do not exceed 16 characters to ensure proper display on Norstar telephones.
5
Repeat step 4 for each VoIP Gateway port.
6 Click the Submit button to save your changes.
7
To save the changes so they are available after a power fail, you must save the changes to
non-volatile memory. To save the changes to non-volatile memory:
a
Click the Save Configuration button.
The Save Configuration to the system screen appears.