Nortel VoIP Gateway, Configuration Manual

Page: 67 / 220

Configuring the IP to Hunt Group Routing 67
Norstar VoIP Gateway Configuration Guide
b
Click the Save Configuration button that is in middle of the screen.
A confirmation message appears when the save is complete.
Configuring the IP to Hunt Group Routing
The IP to Hunt Group Routing Table is used to route incoming IP calls to a group of channels. If an
incoming IP call matches one of the prefixes entered, the call is assigned to a Hunt Group. The call
is then sent to the VoIP Gateway channels assigned to answer that Hunt Group.
To use Hunt Groups you must also do the following.
• You must configure the Channel Select Mode parameter to determine the method in which
new calls are assigned to channels within the hunt groups. For information about how to
enable this option, refer to
“Configuring the Protocol Definition parameters” on page 29 .
• You must assign a Hunt Group ID to the VoIP Gateway channels on the End Point Phone
Number screen. For information about how to assign a Hunt Group ID to a channel, refer to
“Configuring the Channels to Hunt Group parameters” on page 58 .
To configure the IP to Hunt Group Routing Table:
1
Access the web interface.
2 Click the Protocol Management button.
The H323 Gateway Parameters screen appears.
3 Click the IP to Hunt GR Routing tab.
The IP to Hunt Group Routing Table screen appears.
Note: The Save Configuration option is useful for trying out a new configuration.
Simply make the change and try out the new configuration. If you are happy with the
new configuration, save the changes to non-volatile memory. If you are not happy
with the new configuration, do not save the changes to non-volatile memory and
remove power from the VoIP Gateway. The VoIP Gateway will return to the previous
configuration.