Nortel VoIP Gateway, Configuration Manual

Page: 113 / 220

Configuring your Norstar KSU 113
Norstar VoIP Gateway Configuration Guide
Figure 23 Example of IP to Hunt Group Routing settings for shared lines
• To terminate the VoIP Gateway lines onto target lines, you must configure the Digit Delivery
Table. To do this, you must first know the number of receive digits required for your target
lines. Based on the dialed numbers that are received by the VoIP Gateway, you can manipulate
the digit strings until they are the same length as your target line DNs.
You must always add a "D" (wait for dial tone) to the Prefix to Add column even if no other
digits are to be added.
If we assume both PSTN and private network calls can be received over the VoIP Gateway and
we use the example above, then the Digit Delivery Table would look like
Figure 24 . In this
example, the target line DN length is four digits and no extra digits are added.
Entries for:
PSTN long distance
PSTN local
Private Network
Internal call between
different systems