Nortel BayStack 660, Use Manual

Page: 59 / 163

Installing and Starting the AP Manager
203939-B
4-3
Adding a New IP Address
After the software is loaded and power is applied to the BayStack 660 Access
Point, your system may ask you to assign an IP address to an access point. If you
have a DHCP server, the IP address may be assigned from there. However, The
BayStack AP Manager includes two ways to assign an IP address for the access
point. The following section describes these methods.
Using the BOOTP Request Dialog Box to Set the IP Address
If there is no DHCP server, an IP request dialog box ( Figure 4-2 ) opens asking
you to enter an IP address. This happens whenever a new access point is added to
the subnet
Figure 4-2. BOOTP Request Dialog Box
book.fm Page 3 Wednesday, September 22, 1999 1:41 PM