Nortel BayStack 660, Use Manual

Page: 86 / 163

Using the BayStack 660 Wireless LAN Access Point
4-30
203939-B
• To set the hop sequence to auto-negotiate, go to “Enabling
Auto-Negotiate Hop Sequence (FH)” on page 4-34
• To set the channel (DS), go to “Setting the Channel (DS)” on page 4-35
• To set the translation mode, go to “Setting the Translation Mode” on page
4-35
• To set the authorized station list, go to “Setting the Authorized Station
List” on page 4-36
• To enable the authorized station list, go to “Enabling the Authorized
Station List” on page 4-38
• To set the maximum concurrent users, go to “Setting the Maximum
Concurrent Users” on page 4-39
• To set the WEP parameters, go to “Setting the WEP Configuration” on
page 4-40
• To set the expert parameters, go to “Expert Parameters” on page 4-41
The parameters are changed for every access point in a group. Depending on the
options selected, a series of dialog boxes may open requesting new information.
The following section describes each of these options.
Changing the ESSID
To change the ESSID (Extended Service Set Identification):
1.
Choose Configure > Group.
2.
Select the group you want to configure.
The Multiple Configuration Wizard dialog box ( Figure 4-15 ) opens.
3.
Click ESSID.
4.
Click Next.
The ESSID dialog box opens.
5.
Enter a new ESSID of up to 32 alphanumeric characters.
6.
Click Next.
A confirmation dialog box opens asking if the changes you made are correct.
book.fm Page 30 Wednesday, September 22, 1999 1:41 PM