Nortel BayStack 660, Use Manual

Page: 123 / 163

Command Line Interface
203939-B
6-5
SNMP commands— Use these commands to configure/display SNMP
attributes.
snmp show {community | hosts | security} Go to page 6-19
PHY command— Use these commands to configure/display wireless
PHY layer attributes.
phy add-bss-basic-rate <num_Mbps>
phy channel <channel_no>
phy delete-bss-basic-rate <num_Mbps>
phy dwell-time <num_kus>
phy hop-sequence <pattern_no>
phy show
Go to page 6-17
System commands— Use these commands to configure/display
system attributes.
sys essid <ess_id_name>
sys ether-link-mode {10base_2 | 10base_t}
sys gateway <gtw_ip_addr>
sys ip-address <sys_ip_addr> <sys_net_mask>
sys ip-on-wport {enable | disable}
sys load-image <file_name> <tftpd_ip_addr>
sys name <sys_name>
sys show
Go to page 6-20
WEP commands— Use these commands to configure/display Wired
Equivalent Privacy (WEP) attributes.
wep default-key <key_id>
wep exclude-unencrypt {on | off}
wep show
Go to page 6-22
Table 6-1. CLI Command List (continued)
book.fm Page 5 Wednesday, September 22, 1999 1:41 PM