Nortel BayStack 660, Use Manual

Page: 122 / 163

Using the BayStack 660 Wireless LAN Access Point
6-4
203939-B
Fail-over commands— Use these commands to configure/display
fail-over attributes.
fov ether-link-detect {enable | disable}
fov infrstr-ping {enable | disable}
fov ping-target-addr <ip_addr>
fov show
Go to page 6-12
Help commands— Use these commands to display command groups
and command syntax.
help
help <commmod_group>
Go to page 6-11
IAPP commands— Use these commands to configure/display
Inter-Access Point Protocol (IAPP) attributes.
iapp interval <num_sec>
iapp multi-vendor {enable | disable}
iapp show
Go to page 6-14
Logging commands— Use these commands to clear and to display
error log.
log clear
log show
Go to page 6-15
Logout command— Use this command to log out from Access Point.
logout
MAC commands— Use these commands to configure/display wireless
MAC layer attributes.
mac beacon-interval <num_tu>
mac dtim-period <num_beacon_intervals>
mac frag-threshold <num_octets>
mac rts-threshold <num_bytes>
mac show
Go to page 6-16
password command— Use this command to change password
password <password>
reboot command— Use this command to reboot an Access Point.
reboot
Table 6-1. CLI Command List (continued)
book.fm Page 4 Wednesday, September 22, 1999 1:41 PM