Nortel BayStack 660, Use Manual

Page: 147 / 163

Diagnostics and Troubleshooting
203939-B
7-5
Table 7-2 describes the LEDs on a BayStack 660 PC Card (that is, if it is installed
in the BayStack 660 Access Point).
Access Point LEDs Do Not Light
If none of the LEDs lit when you apply power, do the following:
1.
Check the power supply between the access point and the outlet.
Try connecting the power supply directly to a wall outlet, not using an
extension cord or a power strip.
2.
Check the Ethernet connection.
Try another Ethernet cable or connect to another port. Turn the access point
off and then back on.
3.
If necessary, install and activate an Ethernet device (10BASE-T hub or
switch) and connect the access point to it.
4.
Connect the access point to a 10Mbps port on the Ethernet device and
turn the power on the access point off and then back on (100BASE-T
only).
5.
If problems persist, contact Nortel Networks customer support. For
contact details see
http://www.nortelnetwork.com/servsup.com . Go to the
“BayStack Workgroup Products” category, and then use the “ERC” link.
Table 7-2. PC Card LED Descriptions
Color Activity Description
Red On There is power applied to the BayStack 660 PC Card.
Green On There is a wired link from the access point to the network.
Amber Blinking There is data transmission or data receipt activity occurring.
book.fm Page 5 Wednesday, September 22, 1999 1:41 PM