NEC Univerge SV9100, Features And Specifications

Page: 230 / 1402

230
Guide to Feature Programming
Program
Number
Program Name/Description Input Data Default
14-01-08 Basic Trunk Data Setup
– Toll Restriction
For each trunk, enter 1 to Enable Toll
Restriction; enter 0 to Disable Code Restriction.
0 = Restriction Disabled (No)
1 = Restriction Enabled (Yes)
1
15-02-30 Multiline Telephone Basic Data Setup
– Toll
Restriction Class
Select the Toll Restriction Class to be used
when placing a call from a virtual extension.
0 = Vir. Ext. (Virtual Extension
Class)
1 = Real Ext. (Real Extension
Class)
1
20-06-01 Class of Service for Extensions
Assign a Class of Service (1 ~ 15) to
extensions.
Day Night/Mode: 1 ~ 8
Class of Service of Extensions
(1 ~ 15)
Extension port
101 = Class 15
All other
extension port =
Class 1
20-08-02 Class of Service Options (Outgoing Call
Service)
– Trunk Outgoing Calls
Turn Off or On outgoing trunk calling for the
extension.
0 = Off
1 = On
COS 01 ~ 15 = 1
20-13-20 Class of Service Options (Supplementary
Service)
– Account Code/Toll Restriction
Operator Alert (Restricted Operation
Transfer)
Turn Off or On operator alert when an extension
improperly enters an Account Code or violates
Toll Restriction.
0 = Off
1 = On
COS 01 ~ 15 = 0
21-01-10 System Options for Outgoing Calls
– Dial
Digits for Toll Restriction Path
If this option is programmed with an entry other
than 0, a call does not have a talk path unless
the user dials at least the number of digits
entered in this option when placing an outgoing
call.
This means that an entry of 4 or higher in this
program causes a problem when dialing 911.
Since it is only a 3-digit number, the call does
not have a talk path, preventing the emergency
dispatcher from hearing the caller. This option
should be kept at its default setting of 0 to
prevent any problem with dialing 911. If the
system detects the call is answered, by
detecting Reversal in analog trunks, this
restores both
– way voice paths immediately.
0 ~ 24 0
21-01-15 System Options for Outgoing Calls
–
Outgoing Disable on Incoming Line (Toll
Restriction)
Enable or Disable the Incoming Line feature
system wide. When enabled applies code
restriction when hook flash is sent on inbound
trunk followed by dialed digits.
0 = Disable
1 = Enable
0
21-01-16 System Options for Outgoing Calls
–
Supervise Dial Detection Timer
With the Outgoing Disable on Incoming Line
feature, if dial tone is not detected after the
extension answers an incoming line, the system
determines the call is unable to complete and
releases the DTMF receiver.
0 ~ 64800 seconds 20