Mazda 626 Station Wagon, Workshop Manual

Page: 8 / 577

HOW TO USE THIS MANUAL
Procedures for Use
Using the basic inspection (section K)
• Perform the basic inspection procedure before symptom troubleshooting.
• Perform each step in the order shown.
• The reference column lists the location of the detailed procedure for each basic inspection.
• Although inspections and adjustments are performed according to the reference column procedures, if the
cause of the malfunction is discovered during basic inspection, continue the procedures as indicated in the
remarks column.
SHOWS INSPECTION
ORDER
REFERENCE
COLUMN
SHOWS ITEM NAMES FOR
DETAILED PROCEDURES
AU rOMATIC TRANSAXLE BASIC INSPECTION
STEP INSPECTION
SHOW POINTS REQUIRING
ATTENTION BASED ON
INSPECTION RESULTS
Turn ignition switch is on.
Does O/D OFF indicator light (illuminate/go out)
correspond to O/D OFF switch position (on/off)?
Turn ignition switch is on.
When selector lever is moved, are selector lever
position and indicator aligned? Also, when other
ranges are selected from N or P during idling,
does vehicle creep within 1 to 2 seconds?
Inspect the ATF color condition.
Are ATF color and odor normal?
1 Perform line pressure test.
See K-2 Line Pressure Test
1 Is line pressure okay?
1 Perform stall test.
See K-2 Stail Speed Test
1 Is stall speed is okay?
Yes
No
Yes
No
Yes
No
Yes
No
No
ACTION
Go to next step.
Perform symptom troubleshooting No.26 “O/D OFF
indicator light does not illuminate when O/D OFF switch
is turned to on”, or No.27 “O/D OFF indicator light
illuminates when O/D OFF switch is not turned to on".
Go to next step.
Inspect selector lever.
Repair or replace defective areas.
Go to next step.
Repair or replace any defective parts according to
inspection result.
Rush ATX and cooler line as necessary
Go to next step.
Adjust accelerator cable as necessary.
Repair or replace any defective parts according to
inspection result.
Go to next step.
Repair or replace defective parts according to
inspection result.
G I-3