Mazda 626 Station Wagon, Workshop Manual, Page: 238 / 577

AUTOMATIC TRANSAXLE
O - —O : Continuity
Position
Connector terminal
A B
c
D E F G H
I
P
r \_
_r\
R
r \ r-\
L r*
N
r \ —
_ r \
- o O -
D
r \ —
S
r-\
\*r-
L
o - - o
TR SWITCH
H * • "
i G E C
A
H
F D
i
B
COMPONENT SIDE CONNECTOR
(VIEW FROM TERMINAL SIDE)
5. Reinspect for continuity at TR switch.
• If not as specified, replace the TR switch.
(See K2-31 TRANSAXLE RANGE (TR)
SWITCH REMOVAL/INSTALLATION.)
6. Connect the TR switch connector.
7. Install the air cleaner component and fresh-air
duct. (See Section F1.)
8. Connect the negative battery cable.
TRANSAXLE RANGE (TR) SWITCH REMOVAL^
INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct and air cleaner
component. (See Section F1.)
3. Remove the splash shield.
4. Disconnect the TR switch connector.
TR SWITCH CONNECTOR
5. Remove the clip and disconnect the selector
cable.
6. Remove the manual shaft nut, washer and manual
shaft lever.
7. Remove the TR switch.
8. Rotate the manual shaft to the converter housing
side fully, then return 2 notches to set the N
position.
9. Align the protrusion and mark as shown.
K2-31