Mazda 626 Station Wagon, Workshop Manual

Page: 239 / 577

AUTOMATIC TRANSAXLE
10. Install the TR switch while aligning the protrusion
and groove as shown.
M ANU AL SHAFT
17. Install the clip to the SELECTOR CABLE as
shown in the figure.
11. Turn the TR switch so that the neutral hole is in
line with the flat, straight surfaces on either side of
the manual shaft.
CLIP
12. Hand-tighten the TR switch mounting bolts.
13. Connect an ohmmeter between terminals D and I.
18. Shift the selector lever to P position.
19. Turn the manual shaft lever to P position.
20. Connect the selector cable.
T R S W ITC H
C O M P O N E N T S ID E CO N N E C TO R
(V IE W FROM TER M IN A L SIDE)
14. Adjust the switch to the point where there is
continuity between the terminals.
15. Tighten the TR switch mounting bolts.
Tightening torque
7.9— 10.7 Nm
{80—110 kgf-cm, 69.5—95.4 inlbf}
16. Tighten the manual shaft nut.
Tightening torque
32— 46 N m {3.2—4.7 kgfm, 24—33 ft lbf}
21. Inspect for continuity at the TR switch. (See
TRANSAXLE RANGE (TR) SWITCH
INSPECTION, Continuity Inspection.)
• If not as specified, readjust the TR switch.
(See K2-33 TRANSAXLE RANGE (TR)
SWITCH ADJUSTMENT.)
22. Connect the TR switch connector.
23. Install the splash shield.
24. Install the air cleaner component and fresh-air
duct. (See Section F1.)
25. Connect the negative battery cable.
26. Inspect operation of the TR switch. (See K2-30
TRANSAXLE RANGE (TR) SWITCH
INSPECTION, Operating Inspection.)
• If not as specified, readjust the TR switch.
(See K2-33 TRANSAXLE RANGE (TR)
SWITCH ADJUSTMENT.)
K2-32