ON-BOARD DIAGNOSTIC
DTCP1496
Except for GF4A-EL Models
DTC P1496
EGR valve motor coll 1 open or short
DETECTION
CONDITION
• PCM monitors EGR valve coil control signal at PCM terminal 68. If PCM turns EGR valve coil on and
off but voltage at PCM terminal 68 does not change, PCM determines that EGR valve circuit has
malfunction.
POSSIBLE
CAUSE
• EGR valve malfunction
• Connector or terminal malfunction
• Short to ground circuit in wiring between EGR valve terminal E and PCM terminal 68
• Open circuit in wiring between EGR valve terminal E and PCM terminal 68
• Open circuit in wiring between main relay terminal D and EGR valve terminal C
• PCM malfunction
FR O M MAIN
RELAY
T E R M IN A L D
EGR VALVE
® [z~x
X—\J @
(D w
w ©
PCM
EG R VALVE
f
c
\
E
I , 1, 1.1.1. I. I,I.1.1.1.!. I~T
I I I I I I I
PCM
T T T T
68
■
m
r o »; 1;
?
t
V
t
9
'. c a
C O
I I
1
II II T
H A RNE SS SID E CO N N E C TO R
(V IE W FRO M TERM INAL SIDE)
HARNESS SIDE C O N NEC TO R
(VIEW FROM TER M IN A L SIDE)
Diagnostic procedure
STEP
INSPECTION
ACTION
1
VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Check for related Service Information
availability.
• Is any Service Information available?
Yes
Perform repair or diagnosis according to available
Service Information.
• If vehicle is not repaired, then go to next step.
No
Go to next step.
2
CLASSIFY INTERMITTENT CONCERN OR
CONTINUOUS CONCERN
• Turn ignition key to OFF then ON (Engine
OFF).
• Is same DTC present?
Yes
Go to next step.
No
Refer to intermittent concern.
(See F1-142 No.26 INTERMITTENT CONCERNS)
3
CLASSIFY POWER CIRCUIT OR CONTROL
CIRCUIT MALFUNCTION
• Are same DTC and P1497 present?
Yes
Malfunction at EGR valve or power circuit.
Go to next step.
No
Malfunction at EGR valve or control circuit.
Go to Step 6.
4
INSPECT POOR CONNECTION OF EGR
VALVE
• Turn ignition key to OFF.
• Disconnect EGR valve connector.
• Check for poor connection (damaged,
pulled-out terminals, corrosion, etc.).
• Are there any malfunctions?
Yes
Repair or replace terminals, then go to Step 11.
No
Go to next step.
F 1-72
Summary of Contents for 626 Station Wagon
