Mazda 626 Station Wagon, Workshop Manual, Page: 257 / 577

AUTOMATIC TRANSAXLE
Radiator (In Tank Oil Cooler) Installation Note
1. The automatic transaxle oil cooler flushing must
be performed whenever a transaxle is removed for
service because the existing fluid may be
contaminated, and to prevent contamination of
new fluid.
Note
• The flushing must be performed after
installation of the overhauled or replacing
transaxle.
2. Follow the instructions in the manufacturer’s
publication for flushing operation.
Oil Pipe, Hose Clamp, Oil Hose Installation Note
1. Apply compressed air to cooler-side opening, and
blow any remaining grime and foreign material
from the cooler pipes. Compressed air should be
applied for no
less than one minute.
3. Install the new hose clamp onto the hose.
4. Verify that the hose clamp does not interfere with
any other components.
2. Align the marks, and slide the oil hose onto the oil
pipe until it is fully seated as shown.
H O SE
Note
• If reusing the hose, install the new hose clamp
exactly on the mark left by the previous hose
clamp.Then apply force to the hose clamp in
the direction of the arrow in order to fit the
clamp in the place.
K 2-50