Mazda 626 Station Wagon, Workshop Manual

Page: 394 / 577

POWER WINDOW SYSTEM
7. Slowly insert the reset jig into the hole where the
bushing was installed until It stops.
2.5— 3.0 mm {0.099—0.118 in},
LENGTH:
APPROX. 50 mm {2.0 In}
PLATE
8.5 mm
{0.33 in}
R E S E T J IG
8. While inserting the reset jig to the end point,
operate the power window switch to the open
position so that the carrier plate moves to the
lower end (below the motor).
• If the carrier plate is inadvertently raised
above the bracket bolts, return to Step 7.
9. Verify that there is no foreign matter on the
bushing and insert the bushing free of any gaps.
• If the carrier plate is inadvertently raised
above the bracket bolts, return to Step 6.
10. Install the power window regulator to the front
door.
11. Install the front door glass to the power window
regulator.
12. Close the power window by operating the power
window switch.
• In the event that the automatic window return
operates after the window fully closes by auto
close, repeat Step 1.
Caution
• Automatic window return may not operate
immediately after the power window motor
is reset. In the event that auto window
return is operated, be sure to perform Step
12
.
13. Inspect the automatic window return function.
(See S -14 AUTOMATIC WINDOW RETURN
FUNCTION INSPECTION.)
S -1 3