Mazda 626 Station Wagon, Workshop Manual

Page: 447 / 577

WIPER AND WASHER
WIPER AND WASHER
HEADLIGHT CLEANER NOZZLE ADJUSTMENT
1. Use a flathead screwdriver to adjust the headlight
cleaner nozzle so that the fluid properly sprays on
the headlight.
HEADLIGHT CLEANER SWITCH INSPECTION
1. Disconnect the negative battery cable.
2. Remove the light switch.
3. Inspect for continuity between the headlight
cleaner switch terminals using an ohmmeter.
• If not as specified, replace the light switch.
Q—Q : Continuity
Switch
position
Terminal
D F
ON
O
-------------
- - - - - - - o
OFF
Q
0
1
^
* *
*
1
E
i
C A
R P
*
L J
*
F D
*
COMPONENT SIDE CONNECTOR
(VIEW FROM TERMINAL SIDE)
HEADLIGHT CLEANER RELAY
REMOVAL/INSTALLATION
Note
• Because the lock section of the relay is
damaged easily, do not remove the relay from
the bracket unless replacement is necessary.
Always perform an inspection of the headlight
cleaner relay before removal.
1. Disconnect the negative battery cable.
2. Remove the bracket.
3. Disconnect the headlight cleaner relay connector.
4. Remove the headlight cleaner relay.
FP, FS, BRACKET
FS (HI-POWER)
HEADLIGHT
CLEANER RELAY
CONNECTOR
RF TURBO
HEADLIGHT
CLEANER RELAY
HEADLIGHT
5. Install in the reverse order of removal.
HEADLIGHT CLEANER RELAY INSPECTION
1. Remove the headlight cleaner relay.
2. Inspect for continuity between the headlight
cleaner relay terminals using an ohmmeter.
• If not as specified, replace the headlight
cleaner relay.
Q— Q : Continuity
Step
Terminal
A C D
E (B)
1
2
B +
o —
— o
GND
FP, FS,
FS (HI-POWER)
RF TURBO
E
X
A
C
D
C
A
D B
( ): RF TURBO
COMPONENT SIDE CONNECTOR
(VIEW FROM TERMINAL SIDE)
T -2 5