Mazda 626 Station Wagon, Workshop Manual

Page: 371 / 577

ENGINE SPEED SENSING POWER STEERING
ENGINE SPEED SENSING POWER STEERING
STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION
Caution
• Performing the following procedures without first removing the ABS wheel-speed sensor may
possibly cause an open circuit in the harness if It is pulled by mistake. Before performing the
following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate
place where the sensor will not be mistaken while servicing the vehicle.
Note
• On this procedure, tightening torque of the steering gear installation bolts and nuts (@ in the figure) for the
front cross member has only been changed from the current models.
No change has been made for the SSTs and the notes from the current models.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. Inspect the front wheel alignment.
• Adjust as necessary. ____
86—116 | Q |
{8.7— 11.9,63.0—86.0} 67—93
1 Cotter pin
2 Nut
3 Tie-rod end ball joint
4 Transverse member
5 Engine mount component
6 Pressure pipe
7 Return hose and clamp
8 Bolt (Intermediate shaft)
9 Steering gear and linkage
N -4