Mazda 626 Station Wagon, Workshop Manual

Page: 485 / 577

ON-BOARD DIAGNOSTIC
DTC TABLE
• DTCs are common for present and past malfunction diagnosis.
Note
• After a new SAS unit is installed, the air bag system warning light continuously flashes when the ignition
switch is turned to the ON position. This is the deployment authorization standby code output by the SAS
unit. Perform the deployment authorization and restore the system to an operational state.
• If the air bag system warning light does not illuminate or remains illuminated when the ignition switch is
turned to the ON position, inspect and repair the air lighting circuit system of air bag system warning light
and then confirm that the air bag system warning light is operational.
DTC Output signal Malfunction location
1 SAS unit connector poor connection
2
-
jui
SAS unit
3
-JUUl
Power supply of SAS unit
6
« M M
Driver-side air bag module system
7
-JUUUUUUL
Passenger-side air bag module system
11
“ J U L
Driver-side pre-tensioner seat belt system
12 Passenger-side pre-tensioner seat belt system
22
" J U U U L Driver-side side air bag sensor system (Internal
circuit abnormal)
25
“ jim n n n iL
Driver-side side air bag sensor system
(Communication error)
26
“ j i m i M i L
Driver-side side air bag module system
32
" x i n r u i i L
Passenger-side side air bag sensor system
(Internal circuit abnormal)
35
" J W U I I U I J L
Passenger-side side air bag sensor system
(Communication error)
37
" j i n n M M L
Passenger-side side air bag module system
44
" j u u u u u w i L
Short to ground in wiring harness between SAS
unit and occupancy sensor
T -6 3