Mazda 626 Station Wagon, Workshop Manual

Page: 439 / 577

EXTERIOR LIGHTING SYSTEM
EXTERIOR LIGHTING SYSTEM
FRONT FOG LIGHT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front bumper.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the front fog light aiming.
1 Screw
2 Front fog light
FRONT FOG LIGHT AIMING
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level
surface.
3. Seat one person in the driver’s seat.
4. Position the vehicle 3 m {10 ft} in front of a white
screen.
5. While adjusting one fog light, mask the other.
6. Start the engine to charge the battery.
7. Turn the front fog light on.
8. Adjust the brightness border line by turning the
adjusting screw as shown in the figure. Loosen
the screws first, then tighten them.
Note
• If the adjusting screws are tightened first, then
loosened, they will continue to loosen when
the vehicle is in motion and may cause the
front fog lights to become misaligned.
FRONT FOG LIGHT BULB
REMOVAL/INSTALLATION
1. Remove the front fog light.
2. Remove the screw.
3. Remove the front fog light cover.
4. Disconnect the front fog light bulb terminal from
connector.
5. Release the bulb pressing wire.
Caution
• A halogen bulb generates extremely high
heat when it is used. If the surface of the
bulb is soiled, excessive heat will build up
and the light’s life will be shortened. When
replacing the bulb, hold the metal flange,
not the glass.
6. Remove the front fog light bulb.
T -1 7