Mazda 626 Station Wagon, Workshop Manual

Page: 237 / 577

AUTOMATIC TRANSAXLE
Specification
HOLD switch
position
Connector terminal
A B
Normal B+ 0
Depressed 0 0
HOLD SWITCH
j
L
A
B
COMPONENT SIDE
CONNECTOR
(VIEW FROM P
HARNESS SIDE)
Continuity Inspection
1. Disconnect the negative battery cable.
2. Remove the center console.
3. Disconnect the HOLD switch connector.
4. Inspect for continuity at the HOLD switch.
• If the switch is okay, inspect the wiring
harness. (HOLD switch — PCM, HOLD switch
— Body ground.)
• If not as specified, replace the HOLD switch.
(See K2-30 HOLD SWITCH
REMOVAL/I NSTALLATI ON.)
Specification
Q— Q : Continuity
HOLD switch
position
Connector terminal
A B
Normal
Depressed
o -------------
------------ o
Tightening torque
2.0—2.9 N m {20—30 kgf-cm, 18—26 in lbf}
8. Install the HOLD switch terminals and connect the
connector.
9. Install the center conlsole.
10. Connect the negative battery cable.
TRANSAXLE RANGE (TR) SWITCH INSPECTION
Operating Inspection
1 . Verify that the starter operates only when the
ignition switch is at the START position with the
selector lever in
P or N position.
• If not as specified, adjust the TR switch.
2. Verify that the back-up lights illuminate when
shifted to R position with the ignition switch at the
ON position.
• If not as specified, adjust the TR switch.
3. Verify that the indication on the indicator light
meets the lever position in each range when
shifting the selector lever from
P position to L
range. (For vehicles with AT indicator light)
• If not as specified, adjust the TR switch.
Continuity Inspection
Caution
• Water or foreign objects entering the
connector can cause a poor connection or
corrosion. Be sure not to drop water or
foreign objects on the connector when
disconnecting it.
1 . Disconnect the negative battery cable.
2. Remove the fresh-air duct and air cleaner
component. (See Section F1.)
3. Disconnect the TR switch connector.
HOLD SWITCH
J
A
L
B
COMPONENT SIDE
CONNECTOR
(VIEW FROM
TERMINAL SIDE)
5. Install the center console.
6. Connect the negative battery cable.
HOLD SWITCH REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the center console.
3. Disconnect the connector and remove the HOLD
switch terminals. (See K2-58 SELECTOR LEVER
DISASSEMBLY/ASSEMBLY.)
4. Remove the selector lever knob component.
5. Remove the HOLD switch.
6. Install the HOLD switch to selector lever knob
component.
7. Install selector lever knob component.
TR SWITCH
4. Inspect for continuity at the TR switch.
• If not as specified, adjust the TR switch and j
to Step 5.
K 2-30