SETUP
ProMARK X
3-10
If you prefer, you can enter and save up to five user-entered grids. User-
entered grids are non-standard grids that are used in relatively small
operational areas, in areas where grid systems are locally prescribed, and in
areas that are not directly supported by any of the built-in coordinate
systems. A user-defined grid can also be used to increase the accuracy of
position data that is collected in an area that is more accurately described by
a local grid. The user-defined grid utility can also be used to input State Plane
Coordinate Systems. Parameter tables for these inputs are provided in
Appendix 12.
A number of options are available when entering a user-defined grid. Refer
as necessary to Table 4-1 while entering a grid.
Transverse
Mercator
Lambert
Conical
Stereographic
Oblique
Mercator
Polyconic
Any
2 Standard
Parallel
1 Standard
Parallel
N. Polar
S. Polar
Polar - Scale at
Input Parallel
Oblique
Equatorial
Point – Azimuth
Two – Point
Any
Not at Poles
North Pole
South Pole
Either Pole
Not at Equator
Not at Poles
Any
– Lat 1 not at equator
– Lat 1
≠
Lat 2
– Lat 1 & Lat 2 in same
Hemisphere
Any
Always Near 1.0
Yards to Meters
–
All input and display of these coordinates will be in
these units of measure.
In local units of measure as previousl defined
Mapping
Function
Options
Origin
Scale
Local Units
of Measure
False
Coordinates
In local units of measure as previously defined
To enter a user-defined grid, access SETUP 8 and use the
RIGHT ARROW
to scroll through the coordinate systems. Stop when an empty user grid
is displayed and press
ENTER.
Key in any grid name up to 16 characters long and press
ENTER
. Press
the
RIGHT ARROW
to select the mapping function or projection
(transverse mercator, lambert conical, stereographic, oblique mercator,
or polyconic). Press
ENTER
when the desired function/projection is
displayed.
Summary of Contents for GPS PROMARK X
