LS SV-iG5H Series, Manual, Page: 96 / 226

Basic Functions
82
Power On Start select 7.3.7
Group Code Parameter Name Setting Range Default Unit
Drive group drv [Drive mode] 1, 2 0 - 3 1
Function
group 2
H20 [Power On Start select] 1 0 - 1 0
Set H20 to 1.

When AC input power is applied to the inverter with drv set to 1 or 2 {Run via control

terminal} ON, motor starts acceleration.
This parameter is inactive when drv is set to 0 {Run via keypad} or 3 {RS485

communication}.
Particular attention must be directed to this function due to potential hazard as motor starts to
run suddenly upon applying AC input power.
Restart after fault reset 7.3.8
Group Code Parameter Name Setting Range Default Unit
Drive group drv [Drive mode] 1, 2 0 - 3 1
Function
group 2
H21
[Restart after fault reset
selection]
1 0 - 1 0
Set H21 to 1.

Motor starts acceleration if drv is set to 1 or 2 and the selected terminal is ON when a

fault is cleared.
This parameter is inactive when drv is set to 0 {Run via keypad} or 3 {RS485

communication}.
Particular attention must be directed to this function due to potential hazard as motor starts to
run suddenly after the fault is cleared.