LS SV-iG5H Series, Manual, Page: 221 / 226

207
RFI FILTERS
THE LS RANGE OF POWER LINE FILTERS FF ( Footprint ) - FE ( Standard ) SERIES,
HAVE BEEN SPECIFICALLY DESIGNED WITH HIGH FREQUENCY LS INVERTERS. THE
USE OF LS FILTERS, WITH THE INSTALLATION ADVICE OVERLEAF HELP TO ENSURE
TROUBLE FREE USE ALONG SIDE SENSITIVE DEVICES AND COMPLIANCE TO
CONDUCTED EMISSION AND IMMUNITY STANDARS TO EN 50081 -> EN61000-6-3:02
and EN61000-6-1:02
CAUTION
IN CASE OF A LEAKAGE CURRENT PROTECTIVE DEVICES IS USED ON POWER
SUPPLY, IT MAY BE FAULT AT POWER-ON OR OFF. IN AVOID THIS CASE, THE SENSE
CURRENT OF PROTECTIVE DEVICE SHOULD BE LARGER THAN VALUE OF LEAKAGE
CURRENT AT WORST CASE IN THE BELOW TABLE.
RECOMMENDED INSTALLATION INSTRUCTIONS
To conform to the EMC directive, it is necessary that these instructions be followed
as closely as possible. Follow the usual safety procedures when working with
electrical equipment. All electrical connections to the filter, inverter and motor must
be made by a qualified electrical technician.
1-) Check the filter rating label to ensure that the current, voltage rating and part number are
correct.
2-) For best results the filter should be fitted as closely as possible to the incoming mains
supply of the wiring enclousure, usually directly after the enclousures circuit breaker or
supply switch.
3-) The back panel of the wiring cabinet of board should be prepared for the mounting
dimensions of the filter. Care should be taken to remove any paint etc... from the mounting
holes and face area of the panel to ensure the best possible earthing of the filter.
4-) Mount the filter securely.
5-) Connect the mains supply to the filter terminals marked LINE, connect any earth cables
to the earth stud provided. Connect the filter terminals marked LOAD to the mains input of
the inverter using short lengths of appropriate gauge cable.
EMI / RFI POWER LINE FILTERS
LS inverters, iG5H series