LS SV-iG5H Series, Manual, Page: 41 / 226

27
Programming Keypad & Basic operation
B
a
s
ic
O
p
s
.
Navigating codes in a group

When moving from F 1 to F 15 in Function group 1
1
In F 1, continue pressing the

Up (

) key until F15 is
displayed.
2
Moving to F15 has been

complete.

The same applies to Function group 2 and I/O group.
Note
Some codes will be skipped in the middle of increment (

)/decrement (

) for code
change. That is because it is programmed that some codes are intentionally left blank for
future use or left invisible intentionally.
Refer to the Ch.5 for more specific contents
For example, when F24 [High/low frequency limit select] is set to
“0 (No) ”, F25 [High
frequency limit] and F26 [Low frequency limit] are not displayed during code change. But
When F24 is set to
“1(Yes)”, F25 and F26 will appear on the display.