LS SV-iG5H Series, Manual, Page: 95 / 226

81
Basic Functions
B
as
ic
Fu
nc
tio
ns
Rotating direction select via
–10 - +10[V] input of V1
7.3.5
terminal
Group Code Parameter Name Setting Range Default Unit
Drive group frq [Frequency setting] 2 0 - 8 0
drv [Drive mode] - 0 - 4 1
Set frq to 2.

Inverter is operating as the table below regardless of Drive mode setting.

FWD RUN Command REV RUN Command
0 - +10 [V] FWD RUN REV RUN
-10 - 0 [V] REV RUN FWD RUN
►
Motor runs in Forward direction when input voltage to V1-CM is 0-10[V] and FWD RUN
command is active. When input voltage polarity is reversed to
–10-0[V] during FWD
RUN, motor decelerates to stop and runs in reverse direction.
►
When input voltage to V1-CM is 0-10[V] and REV RUN command is active, motor runs
in Reverse direction and if -10-0[V] is input, motor rotating direction is reverse.
FX/RX Run Disable 7.3.6
Group Code Parameter Name Setting Range Default Unit
Drive group drC
[Direction of motor rotation
select]
- F, r F
Function
group 1
F 1
[Forward/Reverse run
disable]
- 0 - 2 0
Select the direction of motor rotation.

0: Forward and Reverse run enable

1: Forward run disable

2: Reverse run disable
