Lexmark X95 series, Service Manual

Page: 911 / 1182

Repair information
4-417
7558- xxx
Go Back
Previous
Next
14. Move the stapler unit frame upward and outward in the direction of the arrow, as shown.
15.
Remove the stapler unit frame.
Warning:
Do not force the stapler unit frame out of the finisher.
Warning:
Be sure to hold the stapler unit frame firmly to avoid dropping it.
Reinstallation notes:
•
Do not force the stapler unit frame into the finisher.
•
Be sure to hold the stapler unit frame firmly to avoid dropping it.
•
Maker sure no harnesses are pinched when replacing the stapler unit frame.
•
Be sure to replace the grounding wire.
•
Ensure that the white connector and the yellow connector are properly replaced.
Stepper motor (buffer/transport) and belt (buffer/transport) removal
1.
Remove the rear upper cover. See
“Rear upper cover removal” on page 4-383
.
2.
Remove the two screws securing the bracket (A) on the rear of the finisher.
3.
Move the bracket slightly.
Note:
It is not necessary to remove the bracket from the finisher. It should only be slightly moved to
provide better access to the stepper motor (buffer/transport) (B) for removal.
4.
Loosen the two screws securing the belt tensioner bracket (C) to the finisher, and move it down as shown.
Rear
D
Yellow connector
White connector
D
Front