Lexmark X95 series, Service Manual

Page: 917 / 1182

Repair information
4-423
7558- xxx
Go Back
Previous
Next
6. Remove the two screws securing the switch (eject cover interlock) (A) from the bracket (B).
7.
Remove the switch (eject cover interlock) (A).
Reinstallation note:
Make sure the media eject unit assembly (C) properly actuates the switch (media eject
interlock) (A) without binding.
Switch (finisher front door interlock) removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See
“Rear upper cover removal” on page 4-383
.
3. Remove the punch waste box (A).
4. Remove the three screws in the front securing the punch waste chute (B).
5. Gently pull down the punch waste chute (B) to gain better access to the switch (finisher front door
interlock) (C).
Right
A
B
Clamp
Clamps
Connector
A
C