Lexmark X95 series, Service Manual

Page: 923 / 1182

Repair information
4-429
7558- xxx
Go Back
Previous
Next
17. Move the upper media exit roll assembly frontward and outward in the direction of the arrow.
18.
Remove the upper media exit roll assembly (F).
Note:
When removing the upper media exit roll assembly (F), do not touch the rubber surface.
Reinstallation notes:
•
Maker sure the flat spot of the upper media exit roll assembly (F) is installed to the rear.
•
When replacing the upper media exit roll assembly (F), do not touch the rubber surface.
Upper pinch guide assembly removal
1. Open the finisher front door assembly.
2. Remove the rear upper cover. See
“Rear upper cover removal” on page 4-383
.
3. Remove the drive motor (buffer/transport). See
“Stepper motor (buffer/transport) and belt (buffer/
transport) removal” on page 4-417
.
4.
Remove the three screws securing the hinge of the upper pinch guide assembly (A) on the rear of the
finisher.
5. Move the upper pinch guide assembly hinge from the rear of the finisher.
6. Remove the upper pinch guide assembly (A) from the inside of the finisher in the direction of the arrow.
Front
F
E-clip
E
Rear
D
F
E
A
Rear
A
Front