Lexmark X95 series, Service Manual

Page: 371 / 1182

Diagnostic aids
3-19
7558- xxx
Go Back
Previous
Next
DEVICE TESTS
Flash Test
This test appears only when a non-defective flash memory is installed. Data is written to the flash card and read
back to check the accuracy. This test destroys all data stored on the flash device.
Warning:
This test deletes all data stored on the flash device. After the test is over, reformat the flash using
Format Flash
in the customer Utilities Menu.
To perform this test:
1.
From the Diagnostics Menu, navigate to
DEVICE TESTS > Flash Test
.
2.
Contents will be lost. Continue?
appears. Touch
Yes
to continue, or touch
No
to return to
DEVICE
TESTS
.
3.
Flash Test Testing...
appears while the test is running.
4.
When the test is complete,
Flash Test Test Passed
or
Flash Test Test Failed
appears.
Quick Disk Test
This menu item appears only when a non-defective disk is installed. This test performs a non-destructive read/
write on one block per track on the disk. Once executed, the test cannot be canceled.
To perform this test:
1. From the Diagnostics Menu, navigate to
DEVICE TESTS > Quick Disk Test
.
2.
Quick Disk Test Testing DO NOT POWER OFF
appears.
3. When the test is complete,
Quick Disk Test Test Passed
or
Quick Disk Test Test Failed
appears.
Disk Test/Clean
Warning:
This test performs a low-level format of the hard disk which will destroy all data and should never be
performed on a good disk. This test will only be used when the disk contains bad data and is
unusable.
Note:
This process does not erase any information stored on the device’s NAND.
DEVELOPMENT MENU
Do not use. For development use only.
Debug Port
Print History
SCANNER TESTS See
“SCANNER TESTS” on page 3-28
.
ASIC Test
See
“ASIC Test” on page 3-28
.
Feed Test
See
“Feed Test (SCANNER TESTS)” on page 3-28
.
Scanner Manual Registration
See
“Scanner Manual Registration” on page 3-29
.
ENGINE ADJUST
ATC SENSOR ADJUST AND
SETUP
Booklet Fold Adj
Finisher Config
EXIT DIAGS