Lexmark X95 series, Service Manual, Page: 451 / 1182

Diagnostic aids
3-99
7558- xxx
Go Back
Previous
Next
Staple positions
There are four stapling modes:
• Front staple (corner) [front corner]
The stapler staples a set of media obliquely (45 degrees) after the rear tamper
aligns the media to the front side.
• Rear staple (corner) [rear corner]
This type of stapling is applied for media with a width of 216 mm or more.
The stapler moves to the rear corner and staples a set of media obliquely (45
degrees) after the front tamper aligns the media to the rear side.
• Rear Staple (Straight) [rear straight]
This type of stapling is applied for media with a width of less than 216 mm.
The Stapler staples a set of media in parallel with the media edge after the front
tamper aligns the media to the rear side.
• Dual Staple [dual]
The Stapler staples a set of media at fixed positions (front/rear sides) in parallel
with the media edge after the front tamper aligns the media to the specified position
for each media size.
Media sizes that allow stapling
Media size that allows stapling depends on stapling positions.
Front
Rear
Process direction
Front
Rear
Process direction
Front
Rear
Process direction
Front
Rear
Process direction