Lexmark X95 series, Service Manual

Page: 363 / 1182

Diagnostic aids
3-11
7558- xxx
Go Back
Previous
Next
Fax Storage Location
This setting determines the location where faxes will be saved.
To change this setting:
1. From the Configuration Menu, navigate to
Fax Storage Location
.
2. Select the location where faxes will be saved.
3. Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
FB Edge Erase
The value of this setting determines the size in millimeters of the “no-print” zone around a flatbed scan job.
To change this setting:
1. From the Configuration Menu, navigate to
FB Edge Erase
.
2. Touch or to change the setting.
3. Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Font Sharpening
This setting allows a user to set a text point-size value from 0 to 150. For all font sizes in a print job equal or
below the text point-size value set, the high frequency screens will be used. For example, if this setting’s value is
“24” then all fonts sized 24 points or less will use the high frequency screens. The panel displays a numeric
keypad interface to allow the user to adjust this setting’s value.
To change this setting:
1.
From the Configuration Menu, navigate to
Font Sharpening
.
2.
Touch or to change the value.
3.
Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
This setting only affects the following emulators: PostScript, PCL, PDF, XL, and XPS.
Format Fax Storage
This setting when executed, deletes faxes that are stored in the location based on the value of the Fax Storage
Location setting. Upon completion of the operation, the screen returns to the Configuration Menu.
To run this setting:
1. From the Configuration Menu, navigate to
Format Fax Storage
.
2. The screen displays
Contents will be lost. Continue?
.
3. Touch
Yes
to format the fax storage, or touch
No
to cancel the operation and return to the Configuration
Menu without saving any changes.
Jobs on Disk
This setting is for clearing jobs that remain on the disk due to buffering.
To perform this function:
1. From the Configuration Menu, navigate to
Jobs on Disk
.
2. Touch
Do Not Delete
or
Delete
.