Lexmark X95 series, Service Manual

Page: 366 / 1182

3-14
Service Manual
7558- xxx
Go Back
Previous
Next
To print the event log:
1. From the Configuration Menu, navigate to
Reports > Event Log
.
2.
Printing EVENT LOG
appears, and the pages print.
Require Standby
To change this setting:
1.
From the Configuration Menu, navigate to
Require Standby
.
2.
Touch or to change the setting.
3.
Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Reset Maintenance Counter Value
This setting enables users to reset the selected Maintenance Count value to zero.
To reset:
1.
From the Configuration Menu, navigate to
Reset Maintenance Counter Value
.
2.
From the options displayed, select the maintenance kit to reset.
3.
Touch
Yes
to reset the maintenance counter value. Touch
No
or
Back
to return to the previous menu.
Reset Separator Roll and Pick Assembly Counter
This setting enables users to reset the separator roller and pick assembly count value to zero.
Short-edge Printing
This setting enables a user to permit or to prohibit the printing of short-edge oriented paper on the device. The
device’s default paper feed orientation is long-edge fed (LEF). However, in order to support added finishing
functionality, the MFP also supports printing with paper fed in the short-edge (SEF) orientation.
If the setting
Disabled
(default) is selected, letter and A4 paper can only be fed long-edge. If they are fed short-
edge, a prompt will ask you to use the correct paper size. When the setting is
Enabled
, you can feed paper
either long-edge or short-edge.
To change this setting:
1.
From the Configuration Menu, navigate to
Short Edge Printing
.
2.
Touch or to change the setting.
3.
Touch
Submit
to save the setting, or touch
Back
to return to the Configuration Menu without saving any
changes.
Size Sensing
This setting controls whether the device automatically registers the orientation, type, and size of paper installed
in an input source equipped with size-sensing hardware.
Tray [x] sensing
By turning the tray [x] sensing setting to
Auto
, every input option equipped with size sensing hardware
automatically registers what size of paper it contains. When this setting is turned
Off
, the printer ignores the size
detected by the hardware and treats the input source as a non-sensing source. The media size can be set by the
operator panel or the data stream.