SERVICE MANUAL
1-4
9G9002 – 2011-08-15
Moving the Shipping Brackets
Shipping brackets are fastened inside the laser imager to keep the parts safe during shipment. You must remove
them, and then reinstall them in a different location (as shown) inside the laser imager. This prevents the shipping
brackets from becoming lost.
Note
If it is necessary to ship the laser imager again, you must return the shipping brackets to the shipping locations.
[1]
To move the back shipping brackets, remove the:
(a)
Back cover (see Adjustments and Replacements,
“Back cover”
)
(b)
4 screws that fasten the 2 shipping brackets
Back view of laser imager
[2]
Rotate the shipping brackets and reattach them in the alternate set of holes on the rail.
[3]
Retain the other 2 bracket screws: Install the screws into any of the empty holes where the bracket was attached
earlier.
[4]
Install the back cover.
Shipping Brackets
Shipping Brackets reattached
