SERVICE MANUAL
3-2
9G9002 – 2011-08-15
Modifications
Important
Check the modification status of the imager at each PM call. If any Type 1 modifications are outstanding, install them
during the call. It is important to fit modifications promptly at scheduled maintenance times to improve and maintain
imager performance to corporate and customer expectations.
EM Call Checklist
If the number of prints since the last PM is more than 18,500, use the 20,000 Cycle PM Procedure instead of the EM
call checklist.
[1]
Repair the print problem that caused the EM call.
[2]
Touch the Pause icon on the display screen to close the film cartridge.
[3]
De-energize the laser imager, and then disconnect the power cord.
[4]
Remove the:
• Top cover
• Left cover (see Adjustments and Replacements,
“Left cover”
).
• Right cover (see Adjustments and Replacements,
“Right Cover”
).
Caution
The processor drum is very hot.
[5]
Remove the 2 rear screws on the
processor drum cover
, and then pivot the cover open toward the front of the
imager.
[6]
Check the processor drum for damage.
If the processor drum is damaged, replace it (see Adjustments and Replacements,
“Processor Drum”
).
Rear Screw
Left Side of Imager
Right Side of Imager
Rear Screw
