Chapter 3
45
Setting Up Measurement Conditions and Display
Setting Up Measurement Conditions
3.
Se
ttin
g
up
Me
asur
eme
nt
Co
ndition
and
Displa
y
Setting up level
To set the measurement signal level, use the following command.
•
:SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude] on page 264
Selecting measurement range
Selecting measurement range mode
To select the measurement range mode (auto range/hold range), use the following
command.
•
[:SENSe][:FIMPedance]:RANGe:AUTO on page 261
Selecting measurement range
To select the measurement range, use the following command.
•
[:SENSe][:FIMPedance]:RANGe[:UPPer] on page 262
The selectable measurement ranges differ depending on the measurement signal frequency.
Therefore, if a newly selected measurement frequency conflicts with the current
measurement range setting, the setting automatically changes to cover the allowable range.
NOTE
Setting up the measurement range automatically sets up the measurement range mode to
the hold range mode.
Selecting measurement time
To select the measurement time (1,2,4,6,8), use the following command.
•
[:SENSe][:FIMPedance]:APERture:TIME on page 249
Selecting cable length
To set the cable length (0 m/1 m/2 m), use the following command.
•
:CALibration:CABLe[:LENGth] on page 174
Setting up averaging function
Turning ON/OFF averaging function
To turn ON/OFF the averaging function, use the following command.
•
[:SENSe]:AVERage[:STATe] on page 229
Setting up averaging count
To set the averaging count, use the following command.
•
